- Messages
- 15,233
- Reaction score
- 9,848
- Points
- 288
I know there are some engineering folks here.
I'm building a router lift station using a stepper motor (T12 lead screw) to lift and lower it.
The question I have is where to put the Linear Shaft Cylinder Liner Rails. In the A, or B position?
Which would be the most efficient? I'm wondering if either position will cause racking?
I'm building a router lift station using a stepper motor (T12 lead screw) to lift and lower it.
The question I have is where to put the Linear Shaft Cylinder Liner Rails. In the A, or B position?
Which would be the most efficient? I'm wondering if either position will cause racking?